The Cli Command Prompt - Siemens SCALANCE S615 Configuration Manual

1.3

The CLI command prompt

Overview
The Command Line Interface prompt shows the following information:
● The mode in which the CLI is currently operating.
Most commands can only be called in a particular mode. You should therefore check the
CLI mode based on the command prompt.
– User Exec mode:
– Privileged Exec mode and configuration modes:
● The selected interface when the CLI is in an Interface Configuration mode.
In the Interface Configuration mode, the parameters are configured for one specific
interface. The command prompt is displayed in the form
placeholder
setting suitable parameters for the
● An identifier when the Trial mode is enabled.
If you first test changes to the configuration and then want to discard them, disable the
Auto save function with the
Changes to the configuration that you have not saved are indicated by an asterisk in front
of the command prompt:
You save the changes to the configuration with the command
the
Note
Upper and lower case
The Command Line Interface does not distinguish between upper case and lower case
letters.
Make sure, however, that names used by the operating system or other programs are
correctly written.
Blank
To use blanks in a text, enter the text in quotes, for example "H e l l o"
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
CLI>
is replaced by the identifier of the Interface. You select the Interface by
$$$
*CLI(...)#
command, you enable the Auto save function again.
auto-save
command.
interface
command. You are then in Trial mode.
no auto-save
.
1.3 The CLI command prompt
CLI(...)#
CLI(config-if-$$$)#
write startup-config
Description
where the
. With
23