Base Bridge-Mode - Siemens SCALANCE S615 Configuration Manual

5.1.2.1

base bridge-mode

Description
With this command, you configure whether or not the device forwards frames with VLAN
tags transparently (IEEE 802.1D/VLAN-unaware mode) or takes VLAN information into
account (IEEE 802.1Q/VLAN-aware mode).
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
base bridge-mode {dot1d-bridge|dot1q-vlan}
The parameters have the following meaning:
Parameter
dot1d-bridge
dot1q-vlan
Result
The device mode is configured.
Further notes
You display the status of this function and other VLAN information with the
info
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Sets the mode "VLAN-unaware" for the device.
VLAN tags are not taken into account or
changed but are forwarded transparently.
Sets the mode "VLAN-aware" for the device.
VLAN information is taken into account.
command.
Network structures
5.1 VLAN
Range of values / notes
-
-n
show vlan device
145