No Vir-Ip - Siemens SCALANCE S615 Configuration Manual

The parameter has the following meaning:
Parameter
subnet
For information on identifiers of addresses and interfaces, refer to the section "Auto-
Hotspot".
Result
The subnet is configured.
Further notes
You display this setting and other information with the
You disable the setting with the
9.3.4.6

no vir-ip

Description
With this command, you specify that the remote station is not offered a virtual IPv4 address.
Requirement
You are in the IPSEC REMOTE END configuration mode.
The command prompt is as follows:
cli(config-ipsec-rmend-X)#
Syntax
Call the command without parameter assignment:
no vir-ip
Result
The setting is configured.
Further notes
You display this setting and other information with the
You enable this setting with the vir-ip command.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Subnet from which the remote
station is offered a virtual IPv4
address
no vir-ip
Range of values / note
Specify the subnet in CIDR notation.
show ipsec remoteend
command.
show ipsec remoteend
Security and authentication
9.3 IPsec VPN
command.
command.
371