Show Vlan - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
Network structures
5.1 VLAN
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
If you do not select any parameter from the parameter list, all entries are displayed.
Result
The entries are displayed.
5.1.1.2
show vlan
Description
This command shows the specific information for all or a selected VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show vlan[brief|id<vlan-range>|summary]
The parameters have the following meaning:
Parameter
brief
id
vlan-range
summary
If you do not select any parameter from the parameter list, the entries of all available
interfaces are displayed.
Result
The information for the selected VLAN is displayed.
140
or
cli#
Description
Shows brief information about all
VLANs
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or
VLAN range
Shows a summary of the VLANs
Range of values / note
-
-
1 ... 4094
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Hide quick links:
Advertisement
Table of Contents
