No Autofwnat - Siemens SCALANCE S615 Configuration Manual

3.5.4.3

no autofwnat

Note
This command is only available with a KEY-PLUG.
Description
With this command, you disable the firewall and NAT rules.
Requirement
You are in the SINEMARC configuration mode.
The command prompt is as follows:
cli(config-sinemarc)#
Syntax
Call the command without parameter assignment:
autofwnat
Result
The firewall and NAT rules are disabled.
Further notes
You enable the setting with the
You display this setting and other information with the
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.
autofwnat
show sinemarc
Functions specific to SCALANCE
3.5 SINEMA RC
command.
113