Show Vlan Port Config - Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.1 VLAN
Syntax
Call up the command with the following parameters:
show vlan learning params[vlan<vlan-range>]
The parameters have the following meaning:
Parameter
vlan
vlan-range
If you do not select any parameter from the parameter list, the entries of all available
interfaces are displayed.
Result
The settings for the automatic learning of addresses are displayed.
6.1.1.11

show vlan port config

Description
This command shows the VLAN-specific information for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show vlan port config[{port<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameter from the parameter list, the entries of all available
interfaces are displayed.
188
Description
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or
VLAN range
or
cli#
Description
Keyword for a port
Type of interface
Module no. and port no. of the interface
Range of values / note
-
1 ... 4094
Range of values / note
-
Enter a valid interface.
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11