Encapsulation Ppp - Allied Telesis AR2050V Command Reference Manual

USB C M C
ELLULAR ODEM OMMANDS

ENCAPSULATION PPP

encapsulation ppp
Overview Use this command to enable PPP encapsulation and create one or more PPP
interfaces over Ethernet, a cellular interface, or a L2TPv2 managed VPN.
Use the no variant of this command to disable PPP encapsulation and remove the
specified PPP interface.
Syntax encapsulation ppp <index>
no encapsulation ppp <index>
Default No PPP encapsulation or interfaces are configured by default.
Mode Interface Configuration mode for an Ethernet interface (e.g. interface eth1), or an
Ethernet sub-interface (e.g. interface eth1.1), or a cellular interface (e.g. interface
cellular0).
L2TP Tunnel Configuration mode for an L2TP tunnel (e.g. l2tp tunnel tunnel0).
Examples To configure a PPP interface with index 0 for Ethernet interface eth1, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
To shut down the ppp0 interface and remove it from Ethernet interface eth1, use
the commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
To set the L2TP tunnel tunnel1 to encapsulate the PPP interface with index 1, use
the commands:
awplus#
awplus(config)#
awplus(config-l2tp-tunnel)#
C613-50186-01 Rev B
Parameter Description
<index>
The PPP interface index number in the range from 0 to 255.
configure terminal
interface eth1
configure terminal
interface ppp0
configure terminal
l2tp tunnel tunnel1
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
encapsulation ppp 0
shutdown
interface eth1
no encapsulation ppp 0
encapsulation ppp 1
393