Backpressure - Allied Telesis AR2050V Command Reference Manual

S C
WITCHING OMMANDS

BACKPRESSURE

backpressure
Overview This command provides a method of applying flow control to ports running in half
duplex mode. The setting will only apply when the link is in the half-duplex state.
You can disable backpressure on an interface using the off parameter or the no
variant of this command.
Syntax backpressure {on|off}
no backpressure
Default Backpressure is turned off by default. You can determine whether an interface has
backpressure enabled by viewing the running-config output; backpressure on is
shown for interfaces if this feature is enabled.
Mode Interface Configuration
Usage The backpressure feature enables half duplex Ethernet ports to control traffic flow
during congestion by preventing further packets arriving. Back pressure utilizes a
pre-802.3x mechanism in order to apply Ethernet flow control to switch ports that
are configured in the half duplex mode.
The flow control applied by the
on full-duplex links, whereas back pressure operates only on half-duplex links.
If a port has insufficient capacity to receive further frames, the device will simulate
a collision by transmitting a CSMACD jamming signal from this port until the buffer
empties. The jamming signal causes the sending device to stop transmitting and
wait a random period of time, before retransmitting its data, thus providing time
for the buffer to clear. Although this command is only valid for switch ports
operating in half-duplex mode the remote device (the one sending the data) can
be operating in the full duplex mode.
To see the currently-negotiated duplex mode for ports whose links are up, use the
command
from the default), use the command
To enable back pressure flow control on interfaces port1.0.1-port1.0.2
Examples
enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50186-01 Rev B
Parameters Description
on
Enables half-duplex flow control.
off
Disables half-duplex flow control.
show interface. To see the configured duplex mode (when different
configure terminal
interface port1.0.1-port1.0.2
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
flowcontrol (switch port)
show running-config.
backpressure on
command operates only
415