Test Interface - Allied Telesis AR2050V Command Reference Manual

I T C
NTERFACE ESTING OMMANDS

TEST INTERFACE

test interface
Overview This command starts a test on a port or all ports or a selected range or list of ports.
Use the no variant of this command to disable this function. The test duration can
be configured by specifying the time in minutes after specifying a port or ports to
test.
For an example of all the commands required to test switch ports, see the
Examples section in this command. To test an Ethernet port, set its speed to 100 by
using the command speed 100.
NOTE
performance.
test interface {<port-list>|all} [time{<1-60>|cont}]
Syntax
no test interface {<port-list>|all}
Mode Privileged Exec
C613-50186-01 Rev B
: Do not run test interface on live networks because this will degrade network
Parameter Description
<port-list>
The ports to test. A port-list can be:
• a switch port (e.g. port1.0.6)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-port1.0.6
• a comma-separated list of the above, e.g.
port1.0.1,port1.0.5-1.0.6
The specified ports must exist.
all
All ports
time
Keyword entered prior to the value for the time duration of the
interface test.
<1-60>
Specifies duration of time to test the interface or interfaces in
minutes (from a minimum of 1 minute to a maximum of 60 minutes).
The default is 4 minutes.
cont
Specifies continuous interface testing until canceled with command
negation.
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
410