Show Interface Status - Allied Telesis AR2050V Command Reference Manual

I C
NTERFACE OMMANDS

SHOW INTERFACE STATUS

show interface status
Overview Use this command to display the status of the specified interface or interfaces.
Note that when no interface or interfaces are specified then the status of all
interfaces on the device are shown.
show interface [<port-list>] status
Syntax
Examples To display the status of ports 1.0.1 to 1.0.4, use the commands:
awplus#
Table 10: Example output from the show interface <port-list> status command
awplus#show interface port1.0.1-1.0.4 status
Port Name
port1.0.1
port1.0.2
port1.0.3
port1.0.4
To display the status of all ports, use the commands:
awplus#
Table 11: Example output from the show interface status command
awplus#sho int status
Port Name
port1.0.1 Trunk_Net
port1.0.2 Access_Net1
port1.0.3 Access_Net1
port1.0.4 Access_Net2
...
eth2
eth1
C613-50186-01 Rev B
Parameter Description
<port-list> The ports to display information about. The port list can be:
• a switch port (e.g. port1.0.6), a static channel group (e.g. sa2) or a
dynamic (LACP) channel group (e.g. po2)
• a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.6, or sa1-2, or po1-2
• a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix switch ports, static channel
groups, and dynamic (LACP) channel groups in the same list
show interface port1.0.1-1.0.4 status
Status
notconnect
notconnect
notconnect
notconnect
show interface status
Status
connected
connected
disabled
connected
notconnect
notconnect
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Vlan Duplex Speed Type
1 auto auto 1000BASE-T
1 auto auto 1000BASE-T
1 auto auto 1000BASE-T
1 auto auto 1000BASE-T
Vlan Duplex Speed Type
trunk a-full a-1000 1000BaseTX
5 full 1000 1000BaseTX
5 auto auto 1000BaseTX
6 auto auto 1000BaseTX
none auto auto 1000BASE-T
none auto auto 1000BASE-T
386