Show Interface - Allied Telesis AR2050V Command Reference Manual

I C
NTERFACE OMMANDS

SHOW INTERFACE

show interface
Overview Use this command to display interface configuration and status.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
Syntax show interface [<interface-list>]
show interface lo
Mode User Exec and Privileged Exec
Usage Note that the output displayed with this command will show MTU (Maximum
Transmission Unit) size for VLAN interfaces, and MRU (Maximum Received Unit)
size for switch ports.
Example To display configuration and status information for all interfaces, use the
command:
awplus#
C613-50186-01 Rev B
Parameter
<interface-list> The interfaces or ports to configure. An interface-list can be:
lo
show interface
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
• an interface such as a VLAN (e.g. vlan1), a switch port (e.g.
port1.0.1), a static channel group (e.g. sa3), a dynamic
(LACP) channel group (e.g. po4), a PPP interface (e.g. ppp0),
an Ethernet interface (e.g. eth1), a tunnel interface (e.g.
tunnel0), or a bridge interface (e.g. br2).
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.6, or sa1-2,
or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
The local loopback interface.
"Getting Started
Guide.
379