Log Permanent (Filter) - Allied Telesis AR2050V Command Reference Manual

Secure, for alliedware plus version 5.4.7-1.x
Table of Contents

Advertisement

L
C
OGGING
OMMANDS
(
)
LOG PERMANENT
FILTER

log permanent (filter)

Overview
This command creates a filter to select messages to be sent to the permanent log.
Selection can be based on the priority/ severity of the message, the program that
generated the message, the logging facility used, a sub-string within the message
or a combination of some or all of these.
The no variant of this command removes the corresponding filter, so that the
specified messages are no longer sent to the permanent log.
log permanent [level <level>] [program <program-name>]
Syntax
[facility <facility>] [msgtext <text-string>]
no log permanent [level <level>] [program <program-name>]
[facility <facility>] [msgtext <text-string>]
Parameter
Description
level
Filter messages sent to the permanent log by severity level.
<level>
The minimum severity of message to send. The level can be specified as one of the following
numbers or level names, where 0 is the highest severity and 7 is the lowest severity:
0|emergencies
1|alerts
2|critical
3|errors
4|warnings
5|notices
6|informational
7|debugging
program
Filter messages by program. Include messages from a specified program.
<program-
The name of a program to log messages from, either one of the following predefined program
name>
names (not case-sensitive), or another program name (case-sensitive) that you find in the log
output:
rip
ripng
ospf
ospfv3
bgp
rsvp
pim-sm
pim-smv6
C613-50186-01 Rev B
System is unusable
Action must be taken immediately
Critical conditions
Error conditions
Warning conditions
Normal, but significant, conditions
Informational messages
Debug-level messages
Routing Information Protocol (RIP)
Routing Information Protocol - next generation (RIPng)
Open Shortest Path First (OSPF)
Open Shortest Path First (OSPF) version 3 (OSPFv3)
Border Gateway Protocol (BGP)
Resource Reservation Protocol (RSVP)
Protocol Independent Multicast - Sparse Mode (PIM-SM)
PIM-SM version 6 (PIM-SMv6)
Command Reference for AR2050V
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
342

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents