Show Ip Route - D-Link DXS-1210-12TC Reference Manual

Parameters
default
NETWORK-PREFIX/PREFIX-
LENGTH
INTERFACE-ID
NEXT-HOP-ADDRESS
primary
backup
Default
None.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Floating static route is supported. This means that there could be two routes with same destination
network address and different next hop. If primary or backup is not specified, the static route will be
automatically determined to be a primary route or a backup route. Primary route has higher priority
than backup route, and is always be used for forwarding when it is active. When primary is down, the
backup route will be used.
Example
This example shows how to create a static route destined to the network where proxy server resides.
Switch# configure terminal
Switch(config)#ipv6 route 2001:0101::/32 vlan 1
Switch(config)#
33-3
This command is used to display the entry in the routing table.
show ip route [[IP-ADDRESS [MASK] | connected | static] | hardware]
Parameters
IP-ADDRESS
MASK
connection
static
hardware
Default
None.
DXS-1210 Series Smart Managed Switch CLI Reference Guide
Specifies to add or delete a default route.
Specifies the network prefix and the prefix length of the static route.
(Optional) Specifies the forwarding interface for routing the packet.
(Optional) Specifies the IPv6 address of the next hop to reach the
destination network. If the address is a link-local address, then the
interface ID also need to be specified.
(Optional) Specifies the route as the primary route to the destination.
(Optional) Specifies the route as the backup route to the destination.

show ip route

(Optional) Specifies the network address of which routing information
should be displayed.
(Optional) Specifies the subnet mask for the specified network.
(Optional) Specifies to display directly connected route.
(Optional) Specifies to display the static route.
(Optional) Specifies to display the routes that have been written into
chip.
fe80::0000:00ff:1111:2233
259