Example: Configuring One-Way Ethernet Frame Delay Measurements With Single-Tagged Interfaces; Table 4: Show Ethernet Delay Command Parameters - Juniper JUNOS OS 10.4 Manual

Table 4: Show Ethernet Delay Command Parameters

Parameter
maintenance-domain name
maintenance-association ma-id
local-mep identifier
remote-mep identifier
count
count
Related
Documentation
Example: Configuring One-Way Ethernet Frame Delay Measurements with
Single-Tagged Interfaces
Copyright © 2012, Juniper Networks, Inc.
NOTE: The only difference in the two commands is the use of the
and
mep-statistics
The fields for these commands are described in
Parameter Range
Existing MD name
Existing MA identifier
1–8191
1–8191
1–100 (default:100)
NOTE: For each MEP, you will see frame counters for sent and received
Ethernet frame delay measurement frames whenever MEP statistics are
displayed.
Ethernet OAM
Ethernet Frame Delay Measurements on page 119
Configuring MEP Interfaces to Support ETH-DM on page 122
Triggering an ETH-DM Session on page 123
Configuring One-Way ETH-DM with Single-Tagged Interfaces on page 125
Configuring Two-Way ETH-DM with Single-Tagged Interfaces on page 130
Configuring ETH-DM with Untagged Interfaces on page 134
This example uses two MX Series routers:
CFM down MEP session on a VLAN-tagged logical interface connecting the two (
on Router and
MX-1 ge-0/2/5
Chapter 11: ITU-T Y.1731 Ethernet Frame Delay Measurements
keyword.
delay-statistics
Table 4 on page
Description
Specifies an existing maintenance domain (MD) to use.
Specifies an existing maintenance association (MA) identifier
to use.
When a MEP has been specified, display statistics only for the
local MEP.
When a MEP has been specified, display statistics only for the
discovered MEP.
The number of entries to display in the results table. By default,
all 100 entries are displayed if they exist.
MX-1 and MX-2
on Router ).
MX-2
125.
. The configuration creates a
ge-5/2/9
125