3.1.1.11
show broadcast-block config
Description
This command shows the broadcast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show broadcast-block config [port<interface-type><interface-id)>]
The parameters have the following meaning:
Parameters
port
interface-
type
interface-id
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 30)".
Result
The broadcast blocking settings for ports are displayed.
3.1.1.12
show unicast-block config
Description
This command shows the unicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
or
cli#
Description
Keyword for a port description
Type or speed of the interface
Slot no. and port no. of the interface
or
cli#
Configuration
3.1 System
Range of values
-
•
gigabitethernet
•
extreme-ethernet
Enter a valid interface name
49