Network structures
6.3 Spanning Tree
Syntax
Call up the command with the following parameters:
spanning-tree bpdufilter{disable|enable}
The parameters have the following meaning:
Parameter
disable
enable
Result
The BPDU transmit status is configured.
6.3.5.10
spanning-tree layer2-gateway-port
Description
With this command, you configure a port as a layer 2 gateway port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
spanning-tree layer2-gateway-port
Result
The port is configured as a layer 2 gateway port.
Further notes
You delete the configuration of a port as a layer 2 gateway port with the command
spanning-tree layer2-gateway-port
You can display other information with the
detail
214
Description
The transfer of BPDU packets is disabled for the port
Default: disabled
The transfer of BPDU packets is enabled for the port
option.
.
show spanning tree interface
SCALANCE XM-400/XR-500 Command Line Interface
Configuration Manual, 05/2014, C79000-G8976-C252-07
no
command with the