Spanning-Tree Layer2-Gateway-Port - Siemens SCALANCE XC-200 Configuration Manual

Network structures
6.3 Spanning Tree
Syntax
Call up the command with the following parameters:
spanning-tree bpdufilter{disable|enable}
The parameters have the following meaning:
Parameter
disable
enable
Result
The BPDU transmit status is configured.
6.3.5.8

spanning-tree layer2-gateway-port

Description
With this command, you configure a port as a layer 2 gateway port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
spanning-tree layer2-gateway-port
Result
The port is configured as a layer 2 gateway port.
Further notes
You delete the configuration of a port as a layer 2 gateway port with the commandno
spanning-tree layer2-gateway-port.
You can display other information with the show spanning-tree interface command
with the detail option.
248
Description
The transfer of BPDU packets is disa‐
bled for the port
The transfer of BPDU packets is ena‐
bled for the port
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Range of values / note
Default: disabled
-
Configuration Manual, 07/2017, C79000-G8976-C361-06