Snmp-Server Enable Trap - Allied Telesis x310-26FT Command Reference Manual

SNMP C
OMMANDS
-
SNMP SERVER ENABLE TRAP

snmp-server enable trap

Overview Use this command to enable the switch to transmit the specified notifications
(traps).
Note that the Environmental Monitoring traps defined in the AT-ENVMONv2-MIB
are enabled by default.
Use the no variant of this command to disable the transmission of the specified
notifications.
snmp-server enable trap {[atmf] [atmflink] [atmfnode] [atmfrr]
Syntax
[auth]
[ospf] [pim] [power-inline] [qsp] [rmon] [thrash-limit] [vcs]
[vrrp]}
no snmp-server enable trap {[atmf] [atmflink] [atmfnode]
[atmfrr] [auth]
[nsm] [ospf] [pim] [power-inline] [qsp] [rmon] [thrash-limit]
[vcs] [vrrp]}
C613-50103-01 REV A
[dhcpsnooping] [epsr] [lldp] [loopprot] [mstp] [nsm]
[dhcpsnooping] [epsr] [lldp] [loopprot] [mstp]
Parameter Description
atmf
AMF traps.
atmflink
AMF Link traps.
atmfnode
AMF Node traps.
atmfrr
AMF Reboot Rolling traps.
auth
Authentication failure.
dhcpsnooping
DHCP snooping and ARP security traps. These notifications must
also be set using the
and/or the
epsr
EPSR traps.
lldp
Link Layer Discovery Protocol (LLDP) traps. These notifications
must also be enabled using the
and/or the
loopprot
Loop Protection traps.
mstp
MSTP traps.
nsm
NSM traps.
ospf
OSPF traps.
pim
PIM traps.
power-inline
Power-inline traps (Power Ethernet MIB RFC 3621).
qsp
QoS Storm Protection
rmon
RMON traps.
thrash-limit
MAC address Thrash Limiting traps.
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ip dhcp snooping violation
arp security violation command.
lldp notifications
lldp med-notifications command.
command,
command,
2293