Table of Contents
Advertisement
NTP C
OMMANDS
SHOW NTP COUNTERS ASSOCIATIONS
show ntp counters associations
Overview
Use this command to display NTP packet counters for individual servers and peers.
show ntp counters associations
Syntax
Mode
User Exec/Privileged Exec
Examples
To display packet counters for each NTP server and peer that is associated with this
device, use the command:
awplus#
Output
Figure 53-2: Example output from show ntp counters associations
Table 53-2: Parameters in the output from show ntp counters associations
C613-50103-01 REV A
show ntp counters associations
awplus#show ntp counters associations
Peer time-server.example.com
sent: 123
received: 122
auth-failed: 0
bogus-origin: 0
duplicate: 0
bad-header: 0
kod-received: 0
Parameter
Peer
sent
received
auth-failed
bogus-origin
duplicate
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
An NTP peer or server that the device is associated with.
The number of NTP packets that this device sent to the
peer.
The number of NTP packets that this device received from
the peer.
The number of NTP packets received that failed
authentication. NTP drops these packets. Packets can only
fail authentication if NTP authentication is enabled with
the
ntp authenticate
command
The number of packets received that have unexpected
timestamps. Such packets are not part of the current
request/reply round and may be faked.
The number of duplicate packets received. Such packets
are at best old duplicates and at worst a replay by a hacker.
Duplicates can happen in symmetric modes if the poll
intervals are uneven.
2268
Advertisement
Table of Contents
