Snmp Trap Link-Status Suppress - Allied Telesis x310-26FT Command Reference Manual

X310 series stackable access switches for alliedware plus version 5.4.6-1.x
Table of Contents

Advertisement

SNMP C
OMMANDS
-
SNMP TRAP LINK
STATUS SUPPRESS

snmp trap link-status suppress

Overview
Use this command to enable the suppression of link status notifications (traps) for
the interfaces beyond the specified threshold, in the specified interval.
Use the no variant of this command to disable the suppression of link status
notifications for the ports.
Syntax
snmp trap link-status suppress {time {<1-60>|default}|threshold
{<1-20>|default}}
no snmp trap link-status suppress
Default
By default, if link status notifications are enabled (they are enabled by default), the
suppression of link status notifications is enabled: notifications that exceed the
notification threshold (default 20) within the notification timer interval (default 60
seconds) are not sent.
Mode
Interface Configuration
Usage
An unstable network can generate many link status notifications. When
notification suppression is enabled, a suppression timer is started when the first
link status notification of a particular type (linkUp or linkDown) is sent for an
interface. If the threshold number of notifications of this type is sent before the
timer reaches the suppress time, any further notifications of this type generated for
the interface during the interval are not sent. At the end of the interval, the sending
of link status notifications resumes, until the threshold is reached in the next
interval.
Examples
To enable the suppression of link status notifications for ports 1.0.2 to 1.0.6 after 10
notifications have been sent in 40 seconds, use following commands:
awplus#
awplus(config)#
awplus(config-if)#
threshold 10
C613-50103-01 REV A
Parameter
Description
time
Set the suppression timer for link status notifications.
<1-60>
The suppress time in seconds.
default
The default suppress time in seconds (60).
threshold
Set the suppression threshold for link status notifications. This is the
number of link status notifications after which to suppress further
notifications within the suppression timer interval.
<1-20>
The number of link status notifications.
default
The default number of link status notifications (20).
configure terminal
interface port1.0.2-1.0.6
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
snmp trap link-status suppress time 40
2287

Advertisement

Table of Contents
loading

This manual is also suitable for:

X310-26fpX310-50fpX310-50ft

Table of Contents