Table of Contents
Advertisement
SNMP C
OMMANDS
-
-
SNMP
SERVER LEGACY
IFADMINSTATUS
snmp-server legacy-ifadminstatus
Overview
Use this command to set the ifAdminStatus to reflect the operational state of the
interface, rather than the administrative state.
The no variant of this command sets the ifAdminStatus to reflect the
administrative state of the interface.
Syntax
snmp-server legacy-ifadminstatus
no snmp-server legacy-ifadminstatus
Default
Legacy ifAdminStatus is turned off by default, so by default the SNMP
ifAdminStatus reflects the administrative state of the interface.
Mode
Global Configuration
Usage
Note that if you enable Legacy ifAdminStatus, the ifAdminStatus will report a link's
status as Down when the link has been blocked by a process such as loop
protection.
Example
To turn on Legacy ifAdminStatus, use the command:
awplus#snmp-server legacy-ifadminstatus
Related
show interface
Commands
C613-50103-01 REV A
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
2303
Advertisement
Table of Contents
