Show Policy Classify Destination Vlan - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show policy classify destination vlan

Specifies a destination VLAN for a hypothetical packet to show how the QoS software in the switch will
handle the packet.
show policy classify {l2 | l3 | multicast} [applied] destination vlan vlan_id
Syntax Definitions
l2
l3
multicast
applied
vlan_id
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate saved policies.
Examples
-> show policy classify l2 destination vlan 3
See the output example given on
Release History
Release 6.6.1; command was introduced.
page 39-156
Uses the Layer 2 classifier for the hypothetical packet.
Uses the Layer 3 classifier for the hypothetical packet.
Uses the multicast IGMP classifier for the hypothetical packet.
Indicates that only applied policies should be examined.
The destination VLAN ID for the flow.
page 39-143 for more information about the potential screen display.
OmniSwitch CLI Reference Guide
QoS Policy Commands
November 2009