Show Policy Classify Destination Mac - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

show policy classify destination mac

Specifies a destination MAC address for a hypothetical packet to show how the QoS software in the switch
will handle the packet.
show policy classify {l2 | l3 multicast} [applied] destination mac mac_address
Syntax Definitions
l2
l3
multicast
applied
mac_address
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
•
Use the qos apply command to activate saved policies.
Examples
-> show policy classify l2 destination mac 00:20:da:05:f6:23
See the output example given on
Release History
Release 6.6.1; command was introduced.
page 39-152
Uses the Layer 2 classifier for the hypothetical packet.
Uses the Layer 3 classifier for the hypothetical packet.
Uses the multicast IGMP classifier for the hypothetical packet.
Indicates that only applied policies should be examined.
The destination MAC address of the Layer 2 flow (for example,
00:20:da:05:f6:23 .
)
page 39-143 for more information about the potential screen display.
OmniSwitch CLI Reference Guide
QoS Policy Commands
November 2009