Timing Belt Drive/Driven Pulley Removal/Installation - TOHATSU BFT250A Service Manual

dummyhead dummyhead
CYLINDER HEAD
TIMING BELT DRIVE/DRIVEN PULLEY
REMOVAL/INSTALLATION
REMOVAL
Disconnect the battery negative (–) cable.
Make sure the remote control lever is in "N" (neutral)
position.
Remove the following:
– Engine cover
– Cooling fan cover (page 5-68)
Remove the four bolts (6 x 16 mm) [1] and cooling fan
[2].
Check the cooling fan for wear or damage, replace it if
necessary.
• Take care not to an impact or drop the cooling fan.
Replace the cooling fan if dropped.
Remove the following:
– Throttle body (page 5-71)
– Alternator belt (page 7-5)
Release the harness clip [1] and main wire harness [2]
from the timing belt covers [3].
Remove the four timing belt cover bolts [4] and timing
belt covers.
14-6
[1]
RIGHT SIDE:
[4]
[1]
LEFT SIDE:
[4]
[1]
[2]
[2]
[3]
[2]
[3]