TOHATSU BFT250A Service Manual page 381

dummyhead dummyhead
Install the timing belt back cover [1] to the cylinder head
and tighten the two special bolts (8 x 29 mm) [2].
Install the timing belt driven pulley [3] and special key
[4] to the camshaft by aligning the key groove [5] of the
driven pulley with the key groove [6] of the camshaft.
Apply engine oil to the threaded part and seat of the
timing belt driven pulley bolt [7] and install it.
• Install the L./R. timing belt driven pulleys in their
proper locations.
Using the special tool as shown, tighten the timing belt
driven pulley bolt [1].
TOOL:
Lock nut wrench, 56 mm [2]
TORQUE: 90 N·m (9.2 kgf·m, 66 lbf·ft)
• When tightening the timing belt driven pulley bolt, do
not rotate the camshaft.
Connect the CMP sensor 4P connector [1].
07LPA-ZV30200
CYLINDER HEAD
[5]
[3]
[4]
[6]
[1]
[1]
[7]
[2]
[1]
[2]
14-13