TOHATSU BFT250A Service Manual page 207

dummyhead dummyhead
Install the fuel pipe [1] to the injector bases and tighten
the two bolts (6 x 35 mm) [2].
Set harness clip A [3] and tighten the bolt (6 x 14 mm)
[4].
Coat new O-rings [5] with engine oil and install them to
the fuel pipe joint [6], and then install the fuel joint hose
[7] to the fuel pipe and tighten the bolt (6 x 25 mm) [8].
• To prevent the fuel leaks, make sure the fuel pipe
joints and fuel joint hose are fixed to the fuel pipes
securely before tightening the bolts.
Coat new O-rings [1] with engine oil and install them to
the fuel pipe joint [2], and then install the fuel joint hose
[3] to the fuel pipe [4] and tighten the bolt [5].
• To prevent the fuel leaks, make sure the fuel pipe
joint and fuel hose A are fixed to the fuel pipe
securely before tightening the bolt.
FUEL SYSTEM
[7]
[6]
[8]
No good
[5]
[2]
[4]
Good
[1]
[2]
[4]
[3]
[5]
Good
[3]
[1]
No good
5-85