dummyhead
dummyhead
ENGINE COVER/COVER LOCK
COVER LOCKING CABLE REMOVAL/
INSTALLATION
REMOVAL
Remove the L./R. engine under cover (page 6-3).
Loosen the washer side nut [1] of the cover locking
cable A [2], and then disconnect the cable from the R.
lock arm [3].
Loosen the washer side nuts [1] of the cover locking
cable A [2] and cover locking cable B [3], and then
disconnect the cables from the L. lock arm [4].
Loosen the washer side nuts [1] of the cover locking
cable B [2], and then disconnect the cable from the front
lock arm [3].
INSTALLATION/ADJUSTMENT
Set the adjusting nut position of cover locking cable B
[1] (shorter cable) to the measurement as shown.
6-6
[1]
[1]
[3]
[4]
[3]
[2]
A SIDE
10 mm (0.4 in)
20 mm (0.8 in)
B SIDE
[3]
[2]
[1]
[2]
[1]
[1]