TOHATSU BFT250A Service Manual page 299

dummyhead dummyhead
Apply grease to the sliding surface of the clutch fork [1].
Set the clutch fork in the indicated position of the
overrunning clutch groove [2] as shown.
Install the overrunning clutch [1] assembly on the front
bracket [2].
• Install the overrunning clutch by aligning the
projection [3] on the outer surface of the internal
gear with the groove [4] in the front bracket and
groove [5] on the outer surface of the internal gear
with the bolt hole groove [6] in the front bracket.
Install the packing [1].
• Install the packing by aligning the projections [2] on
the packing with the grooves in the front bracket,
and aligning the notches [3] on the packing with the
bolt hole in the front bracket.
• Make sure the projection on the packing facing
forward the clutch fork side.
Apply grease to the planetary gears [1], steel ball [2],
and the internal gear [3].
Install the three planetary gears and steel ball.
STARTING SYSTEM
[5] [3] [4]
[1]
[1]
[3]
[2]
[1]
[2]
[1]
[6]
[2]
[2]
[3]
[4]
[2]
[3]
9-13