TOHATSU BFT250A Service Manual page 561

dummyhead dummyhead
Apply marine grease to the water seal contact surface
and spline of the shift shaft A [1].
Install the washer (14 mm) [2], E-ring [3], C-ring [4], and
shift shaft A to the mount case [5].
Install the under cover seal A [1], two mount rubbers [2],
two rubber spacers [3], two upper mount stopper
washers [4], and two bolts (12 x 200 mm) [5] into the
mount case.
Note the installation direction of the upper mount
stopper washer.
Install the mount rubber holder [6], three washers (10
mm) [7], and three bolts (10 x 32 mm) [8], and tighten
the bolts.
Apply soapy water to the outer circumference of a new
mount case water seals [1].
Drive the water seals one by one into the mount case
using the special tools.
Note the installation direction of the water seals.
TOOLS:
Driver [2]
Attachment, 32 x 35 mm [3]
Pilot, 22 mm [4]
After installing the water seals, apply 2 – 4 g (0.07 –
0.14 oz) of water resistant molybdenum disulfide
grease to the seal lips and the adjacent areas.
[1]
[2]
[7]
[1]
07749-0010000
07746-0010100
07746-0041000
[4] [3]
[8]
[2]
[1]
[4]
MOUNT
[5]
[6]
[2]
[3]
[4]
[5]
[3]
18-9