TOHATSU BFT250A Service Manual page 584

dummyhead dummyhead
TRIM/TILT
Remove the rod guide [1] and piston rod B [2] from the
trim cylinder slowly.
Remove the rod guide from piston rod B.
Drain the ATF from the trim cylinders.
Remove the O-ring [1] and backup ring [2] from piston
rod B [3].
Remove the O-ring [1] from the rod guide [2].
Insert a sharp-end screwdriver [3] into the gap between
the dust seal [4] and the rod guide.
Lift the dust seal and remove it from the rod guide.
Take care not to damage inside the rod guide during
this operation.
Remove the oil seal [5] in the rod guide in the same
manner.
• Be careful not to damage the oil seal installation
surface of the rod guide.
Replace the rod guide with a new one, if damaged.
19-22
[2]
[1]
[3]
[2]
[1]
[4]
[5]
[2]
[1]
[3]
[4]