TOHATSU BFT250A Service Manual page 609

dummyhead dummyhead
SHIFT CONTROL CABLE REMOVAL/
INSTALLATION
REMOVAL
Remove the front separate cover (page 6-3).
Slide the lock plate [1] backward and remove the shift
control cable [2] from the link rod [3].
INSTALLATION
• Before installing the cable to the outboard motor,
check the following.
– Make sure that the cable is connected to the
remote control box side securely.
– Make sure the assist spring tip push the neutral
switch and click spring roller is in the shift arm
groove.
1. Apply marine grease to the mating surface of the
shift pivot.
2. Move the remote control lever [1] fully to the "F"
(Forward) side [2].
Return the lever to the "N" (Neutral) position [3]
slowly.
3. With the lever returned to the "N" (Neutral) position,
mark a mark at the cable outer seal end [4] on the
inner cable [5] (Mark (A) [6]).
[1]
[2]
[5]
[6]
[4]
CONTROLS
[3]
[3]
[1]
[2]
20-3