TOHATSU BFT250A Service Manual page 241

dummyhead dummyhead
SOLENOID VALVE INSPECTION
Remove the IAB control solenoid valve (page 5-102).
Measure the resistance between the IAB control
solenoid valve [1] terminals.
Resistance: 37 – 44 Ω
If the resistance is out of specification, replace the IAB
control solenoid valve.
Check air flow from A to B. Air should not flow.
Connect the 12 V battery to the solenoid valve side 2P
connector terminals.
Air should flow from A to B when the battery is
connected.
FUEL SYSTEM
[1]
B
A
5-119