dummyhead
dummyhead
OTHER ELECTRICAL
SWITCH PANEL INDICATOR WIRE
HARNESSES REMOVAL/
INSTALLATION
REMOVAL
Remove the following:
– Front separate cover (page 6-3)
– Shift control cable pivot (page 20-3)
– Throttle control cable pivot (page 20-6)
Loosen the screw and remove the grommet band [1],
then remove the under case grommet A [2].
Remove the bolt (6 x 16 mm) [3] and remote control
cable plate [4].
Be careful not to damage the starter cables by letting
them fall: use a string or wire to hang the starter cables
from the engine hanger bracket.
Remove the bolt (6 x 14 mm) [5] and harness bracket
[6], and release the two harness band clips [7].
Disconnect the switch panel wire harness 14P
connector [8] and indicator wire harness 6P connector
[9].
[3]
10-8
[4]
[6]
[5]
[2]
[8]
[9]
[7]
[1]