TOHATSU BFT250A Service Manual page 295

dummyhead dummyhead
Remove the overrunning clutch [1] from the front
bracket [2].
Remove the clutch fork [3] from the overrunning clutch.
Secure the gear shaft [1] by placing a wood block [2]
under the gear shaft assembly.
Secure the gear shaft assembly, being careful that the
internal gear does not contact the wood block.
Prepare a pipe [3] of the following dimensions.
I.D.:
O.D.:
LENGTH: approx. 20 mm (0.8 in)
Set the pipe on the gear shaft stopper [4] and drop the
gear shaft stopper by tapping on the pipe.
Remove the snap ring [5] using a screwdriver or
equivalent tool.
Remove the gear shaft [1] and gear shaft stopper [2].
Remove the internal gear [3] and overrunning clutch [4].
approx. 11 mm (0.4 in)
approx. 15 mm (0.6 in)
STARTING SYSTEM
[1]
[3] [2]
[3]
[1]
[5]
[2]
[2]
[3]
[4]
[1]
[4]
9-9