Cylinder Block Anode Removal; Installation; Flywheel Removal/Installation - TOHATSU BFT250A Service Manual

dummyhead dummyhead
CYLINDER BLOCK

CYLINDER BLOCK ANODE REMOVAL/

INSTALLATION

Remove the oil pump (page 12-9).
Remove the two screws (5 x 16 mm) [1] and two anode
metals [2].
Installation is in the reverse order of removal.

FLYWHEEL REMOVAL/INSTALLATION

REMOVAL
Remove the oil pump (page 12-9).
Set the special tool on the starter motor mounting
position and tighten the two suitable bolts [1].
TOOL:
Ring gear holder [2]
Remove the eight flywheel boss bolts [3] and remove
the flywheel boss [4].
Remove the eight flywheel bolts [1] and the flywheel [2].
Check the flywheel (page 15-26).
15-4
[1]
070PB-ZY3A100
[3]
[2]
[1]
[1]
[1]
[2]
[4]
[2]