TOHATSU BFT250A Service Manual page 213

dummyhead dummyhead
Apply engine oil to new O-ring [1].
Install the O-ring to the slit of fuel pipe joint [2].
Connect fuel hose A [3] to the vapor separator.
Install and tighten the bolt (6 x 25 mm) [4].
Connect the vacuum tubes [1] to the vacuum tank [2]
(the fuel tube with the check valve connects to the lower
side of the vacuum tank joint.)
Make sure the tubes are connected properly (page 2-
34).
After checking, tighten the vapor separator with the bolt/
washer (8 x 35 mm) and two bolts (8 x 35 mm) securely.
Connect the fuel pump (high pressure side) 2P
connector [1] and set the connector to the connector
holder of the fuel pump.
Clamp the main wire harness [2] to the harness clamp
[3] of the fuel pump.
Install the intake manifold (page 5-76).
[3]
[4]
[2]
[2]
FUEL SYSTEM
[2]
[1]
[1]
[3]
[1]
5-91