TOHATSU BFT250A Service Manual page 557

dummyhead dummyhead
MOUNT CASE DISASSEMBLY/
ASSEMBLY
DISASSEMBLY
Remove the mount case (page 18-4).
Remove the oil pump rubber [1] from the mount case.
Remove the two water seals (22 x 35 x 7 mm) [2] from
the mount case.
Remove the three bolts (10 x 32 mm) [1], three washers
(10 mm) [2], and mount rubber holder [3].
Remove the two mount rubbers [4], two rubber spacers
[5], two upper mount stopper washers [6], two bolts (12
x 200 mm) [7] and under cover seal A [8] from the
mount case.
Check the under cover seal A deterioration or damage,
and replace it if necessary.
[1]
[2]
[1]
[2]
[8]
MOUNT
[3]
[4]
[5]
[6]
[7]
18-5