Installation; Ecm Removal/Installation; Ecm Bracket Removal - TOHATSU BFT250A Service Manual

dummyhead dummyhead

ECM REMOVAL/INSTALLATION

Disconnect the battery negative (–) cable, then the
positive (+) cable from the battery.
Remove the engine cover.
Remove the two bolts (6 x 20 mm) [1] and the ECM [2].
Disconnect the ECM connector A [3] and B [4].
Installation is in the reverse order of removal.

ECM BRACKET REMOVAL/

INSTALLATION

Disconnect the battery negative (–) cable, then the
positive (+) cable from the battery.
Remove the ECM (page 10-5).
VTEC SPOOL SOLENOID
VALVE 1P CONNECTOR
POWER TILT SWITCH
3P CONNECTOR
ECM BRACKET
GROMMET (4)
BOLT/WASHER
(6 x 27 mm) (4)
WIRE HARNESS
CLIP
BOLT (6 x 10 mm) (2)
FUEL STRAINER
[4]
[3] [2]
CKP SENSOR 2P CONNECTOR
COLLAR (4)
CABLE CLIP
OTHER ELECTRICAL
[1]
10-5