TOHATSU BFT250A Service Manual page 585

dummyhead dummyhead
Hold the cylinder with a vise (page 19-21).
Make sure that the piston rod A [1] is in the fully
extended position.
Set the special tool on the cylinder cap [2] as shown,
and remove the piston rod A.
TOOL:
Pin wrench, 6 mm [3]
Remove the piston rod A [1] from the cylinder [2].
Remove the two O-rings [3] from the cylinder cap [4].
Remove the free piston [1], backup ring [2], and O-ring
[3] from the cylinder [4].
Check the sliding surface of the free piston for wear and
damage and replace if necessary.
07SPA-ZW1010A
[2]
[1]
[1] [2]
TRIM/TILT
[3]
[2]
[1]
[4]
[3]
[3]
[4]
19-23