TOHATSU BFT250A Service Manual page 591

dummyhead dummyhead
Install the filter B [1] and drive joint [2] on the pump [3].
After installation, check filter B for bubbles. Remove the
bubbles with the oil bottle [1] or an equivalent tool if
necessary.
Be sure to remove the air bubbles, or it will cause air in
the system.
After removing the air bubbles, fill the pump fully with
ATF again.
Apply ATF to a new O-ring [1] and install it on the power
tilt motor [2].
[2]
[1]
[1]
TRIM/TILT
[3]
[1]
[2]
19-29