TOHATSU BFT250A Service Manual page 601

dummyhead dummyhead
ASSEMBLY
Apply grease to the oil seal lips.
Apply grease to a new O-ring [1] and install it to the
front bracket groove [2].
Set the brush holder A [3] and brush terminal [4] above
the motor wire (Green wire) terminal [5] and loosely
tighten the screw (4 x 10 mm) [6].
Be sure that the motor wire (Green wire) terminal and
the brush assembly wire terminal contact the respective
projections [7] on brush holder A, and then tighten the
screw.
Install the breaker [8] and brush holder B [9], and
tighten the screw (4 x 10 mm) [10].
Do not touch the bimetal part of the breaker.
Connect the motor wire (Blue wire) terminal [11] to the
breaker.
Install the two springs [12] in the place under the brush
holders A and B.
Set the two brushes [13] on the brush holders.
Apply grease to the sliding surface of the armature shaft
[1], taking care that the commutator surface [2] is not
contaminated with grease.
Install the armature on the front bracket while pushing
the brush terminal into the holder.
• Be careful not to damage the brushes when
installing the armature into the front bracket.
[1]
[11]
[2]
[13]
[9]
[1]
[10]
[11]
[2]
TRIM/TILT
[4]
[6]
[5]
[12]
[8]
[4]
[7]
[3]
[5]
[1]
[1]
19-39