dummyhead
dummyhead
Place the armature on an armature tester (commercially
available.)
Hold a hacksaw blade close to the armature core.
If the blade is attracted to the core or vibrates when the
core is turned, the armature is shorted. Replace the
armature.
POWER TILT SWITCH INSPECTION
Disconnect the power tilt switch 3P connector [1].
Attach the tester lead to each terminal and check for
continuity.
When the switch is pushed "UP" or "DN", there should
be continuity between the terminals marked with a
circle in the table below.
[1]
UP
DOWN
Lg
W/Bl
FREE
UP
DOWN
:Continuity
TRIM/TILT
Lb
19-43