TOHATSU BFT250A Service Manual page 588

dummyhead dummyhead
TRIM/TILT
Apply ATF to a new O-ring [1] and Install it on the
bottom (i.e. nut side) of the piston rod A [2].
Apply ATF to a new O-ring [1] and Install it on the
cylinder cap [3] of the piston rod A.
With the piston rod A fully extended, install the piston
rod A slowly in the piston rod chamber of the cylinder
[4].
Loosely tighten the cylinder cap.
Do not install the piston rod A by pushing it in the piston
rod chamber.
Tighten the cylinder cap [1] to the specified torque using
the special tool as shown.
TOOL:
Pin wrench, 6 mm [2]
TORQUE: 208 N·m (21.2 kgf·m, 153 lbf·ft)
• Make sure the torque wrench [3] stays perpendicular
[4] to the special tool. If the torque wrench is not held
90 degrees to the tool, the torque reading will be
incorrect.
Apply ATF to a new O-ring [1] and new backup ring [2],
and install them on the piston rod B [3].
• Install the backup ring on the piston rod B with care
not to break it.
19-26
[4]
07SPA-ZW1010A
[3]
[1]
[2]
[1]
[2]
[3]
[4]
[3]
[2]
[1]
[2]