TOHATSU BFT250A Service Manual page 279

dummyhead dummyhead
Install the washer [1] onto the rotor shaft [2].
• When installing the rear cover housing, be sure that
the washer is positioned within the bearing
circumference.
Install the rear housing [3] to the stator by aligning the
holes [4] of the rear housing with the terminals [5] of the
stator.
Install the insulators [6] to the terminals.
Install and tighten the four nuts [7].
Install the seal ring [1] onto the rotor shaft [2].
Install the rectifier [3] by aligning the terminals of it with
the stator terminals [4].
Install and tighten the four screw/washers (4 x 7 mm)
[4].
Install the IC regulator [1] and tighten the two screws (4
x 25 mm) [2] and the screw (4 x 6 mm) [3].
• Do not allow the rotor shaft [4] and slip rings [5] to
become contaminated with oil or grease.
CHARGING SYSTEM
[6]
[3]
[1]
[2]
[3]
[1]
[2]
[5] [4]
[2]
[7]
[4]
[5]
[4]
[4]
[3]
[1]
7-13