TOHATSU BFT250A Service Manual page 472

dummyhead dummyhead
GEAR CASE (STANDARD ROTATION)
PROPELLER SHAFT HOLDER
REMOVAL/INSTALLATION
Drain the gear case oil (page 3-7).
Remove the following:
– Propeller (page 16-6)
– Gear case (page 16-8)
– Extension separator (XXA type: page 16-8)
– Shift rod (page 16-14)
Remove the two bolts (12 x 45 mm) [1], two washers
(12 mm) [2].
Insert a screwdriver or equivalent tool into the recess [3]
in the propeller shaft holder [4] and remove the
propeller shaft holder from the gear case.
Remove the thrust shim [5].
Replace the O-ring [6] with a new one and coat the O-
ring with marine grease.
At installation, check that the shift slider [7] of the
propeller shaft holder is set on the reverse bevel gear
side [8].
Apply marine grease to the propeller shaft holder
seating surface.
Installation is the reverse order of removal.
Perform the gear case pressure check (page 16-45).
[4]
[2]
[1]
16-18
[7]
[8]
[6]
[3]
[5]
[7]