TOHATSU BFT250A Service Manual page 206

dummyhead dummyhead
FUEL SYSTEM
Coat two O-rings [1] with engine oil and install them to
the fuel pipe joint [2], and then install the fuel joint hose
[3] to the fuel pipe [4] and tighten the bolt (6 x 25 mm)
[5].
• To prevent fuel leaks, make sure the fuel pipe joints
and fuel joint hose are fixed to the fuel pipes
securely before tightening the bolts.
Install the fuel pipe [1] to the injector base by passing
the fuel joint hose [2] to the vapor separator air vent
hose [3] back side and tighten the two bolts (6 x 35 mm)
[4].
Set harness clip A [5] and tighten the bolt (6 x 14 mm)
[6].
5-84
[1]
[5]
No good
[1]
[5]
[6]
[4]
[4]
[2]
[3]
Good
[3]
[2]
[1]