TOHATSU BFT250A Service Manual page 216

dummyhead dummyhead
FUEL SYSTEM
Turn the separator cover [1] and position the fuel tube
inlet joint [2] with the "I" mark [3] on the suspension in
the range [4] as shown.
Tighten the three separator cover screw/washers (5 x
12 mm) [5] to the specified torque.
TORQUE: 3.4 N·m (0.35 kgf·m, 2.5 lbf·ft)
INSTALLATION
Install the water separator [1] to the bracket [2].
Connect the fuel tubes [3] to the water separator
securely.
Connect the fuel tube D [4] to the fuel drain valve [5]
securely.
Install the water separator/water level sensor 2P
connector [6] to the stay [7].
Connect the 2P connector and clamp it with the harness
clip [8].
Install the L. engine under cover (page 6-4).
Connect the battery positive (+) terminal and negative
(–) terminal.
5-94
[4]
[1]
[6] [7]
[4]
[2]
[8]
[2]
[5]
[3]
[5] [4]
[1]