Installation; Ebt Sensor Removal/Installation - TOHATSU BFT250A Service Manual

dummyhead dummyhead
EBT SENSOR REMOVAL/

INSTALLATION

Remove the cylinder head (page 14-22).
Disconnect the 2P connector [1] and remove the EBT
sensor [2].
Replace the O-ring with a new one [3] and coat it with
engine oil.
Apply liquid sealant (Threebond
Hondabond HT, Hondabond 4, or equivalent) to the
threads and seating surface of the EBT sensor.
• Do not apply liquid sealant to the thermistor [4].
Install and tighten the EBT sensor to the specified
torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the 2P connector to the EBT sensor.
Install the cylinder head (page 14-24).
® #1201 or #1215,
[4]
FUEL SYSTEM
[3]
[1]
[2]
5-105