TOHATSU BFT250A Service Manual page 257

dummyhead dummyhead
Apply marine grease to the front lock arm [1] cable end
insertion part.
Insert the cable end (A side) [2] of cover locking cable B
[3] into the front lock arm.
Install cover locking cable B so that the cable aligns
with the groove of the front cover bracket [4], and
tighten the washer side nut [5] to the specified torque.
TORQUE: 3.5 N·m (0.36 kgf·m, 2.6 lbf·ft)
Apply marine grease to the L. lock arm [1] cable end
insertion part.
Insert the cable end (B side) [2] of cover locking cable B
into the L. lock arm.
Install cover locking cable B so that the cable aligns
with the groove of the L. cover bracket [3], and tighten
the washer side nut [4] to the specified torque.
TORQUE: 3.5 N·m (0.36 kgf·m, 2.6 lbf·ft)
There should be 1.5 mm (0.06 in) of clearance between
the hole [1] of the L. lock arm [2] and the cable end [3].
Readjust if the clearance is out of specification.
Set the adjusting nut position of cover locking cable A
[1] (longer cable) to the measurement as shown.
ENGINE COVER/COVER LOCK
[2]
[1]
[4]
[3]
[3]
1.5 mm (0.06 in)
15 mm (0.6 in)
A SIDE
B SIDE
[3] [5]
[4]
[2]
[1]
[1]
[2]
[1]
14 mm (0.6 in)
6-7