TOHATSU BFT250A Service Manual page 439

dummyhead dummyhead
Install the dowel pin [1].
Align the dowel pin position, and install a new O-ring [2]
and timing belt tensioner base [3].
Install and tighten the three timing belt tensioner base
bolts (10 x 40 mm) [4] to the specified torque.
TORQUE: 45 N·m (4.6 kgf·m, 33 lbf·ft)
Install and tighten the bolt (6 x 22 mm) [5].
Position the two main wire harness ground terminals [1]
against the stopper [2] of the crankcase, then install and
tighten the two bolts (6 x 12 mm) [3].
CYLINDER BLOCK
[4]
[1]
[3]
[5]
[3]
[1]
[2]
[2]
15-25